Elbows in 1.5 mm sheet steel are used to change the direction of the flue pipe between the stove or fireplace insert and the chimney. We offer 45° and 90° versions in diameters of 120, 130, 150, 160, 180 and 200 mm.
A good choice for anyone building a new flue gas run or replacing a part on an existing one.
Elbows
6 products in this category.
Filters (active)

Elbow 90/130mm/1.5mm
5.0 (4)
Elbow 90/160mm/1,5mm

Elbow 45/130mm/1,5mm

Elbow 90/200mm/1,5mm

Elbow 45/160mm/1,5mm

Elbow 45/200mm/1,5mm
How to choose the right elbow
The diameter of the appliance outlet and the chimney entry is the deciding factor. The elbow must have the same internal diameter as the rest of the run, otherwise it creates unnecessary resistance and weakens the draught. You can find the diameter in the stove's technical data sheet or measure it at the spigot of your existing flue pipe.
The second step is the angle. A 90° elbow is used for a direct connection into a chimney in the wall behind the appliance. 45° elbows suit situations where the run needs to change direction more gradually – the flue gases meet less resistance and less soot builds up in the bend. Two 45° elbows often get around a beam, shelf or awkwardly placed chimney entry more elegantly than a single sharp bend.
Things to consider when fitting
- Keep the number of bends in the run to a minimum, as each one reduces the draught.
- Fit the parts in the direction of flue gas flow, i.e. socket from the appliance towards the chimney.
- Also work out the pipes you need and an adaptor or end piece to go with the elbow.
- For easy cleaning, it is a good idea to add a piece with an inspection opening to the run.
1.5 mm sheet steel
Thicker material better withstands heat stress and mechanical damage during cleaning, so it is suitable for visible sections of flue pipe in living spaces and for runs that are cleaned more often. It is a long-lasting solution that will see you through many heating seasons.